Hey thanks for the help so far, but my major question is about which slot
holds what!
My gasket has four slots, I am sure two of them must be involved with the
finish strip.
My question is about which channel holds the windshield.
The gasket is slightly more rounded on one side--but not much. On one side
there are two grooves. One is wide (about 3/8"?), the other is narrow. They
are separated by a thin rib of rubber. On the other side there is a wide(but
deeper) groove, and a narrow one separated by a wider rib (about a 1/4
"-maybe a little less). The deeper wide groove on this side has small ribs
running inside it. I am guessing that this is the one that holds the
windshield. Right?
Thanks for the help
Joe Garrison
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|