Re: prop/drive shaft

["MICHAEL C ROSS" <mikeross@prodigy.net>]

>It is a bit easier for the propshaft as you mark the two flanges at either
end, unbolt and take the shaft out then follow the >instuctions.

What happens if you forget to mark the flanges at the ends of the propshaft?
I know you are supposed to do this, but on my first one I didn't do it, and
I haven't noticed any problems.  In the future I will mark them, but would
like to know why and did I just get lucky on my first attempt?

TIA,

Mike                http://pages.prodigy.net/mikeross