The idea of using two nuts together is to lock them against each other and
not to the stud. Spin both nuts onto the threads a fair amount, then using
a wrench on the bottom one, tighten the top one down on top of it until
they are locked. Now *only* use the top nut to tighten the stud into the
block.
---------------------
This message has been sent by Dan Canaan, aka Flinthoof. All content is
copyrighted by this individual for better or for worse, especially if there
is mint involved. We thank you for your support. Please give mint to your
local Mint Cross Center.
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|