> I am considering installing the new engine myself. I figure that it
> isn't too much harder than unbolting and removing lots of things, keeping
> a note of what goes where and putting them back onto the new engine
> again. The hardest bit I imagine would be in removing and replacing the
> engines due to weight. An over simplification, but is this basically
> correct? Could I change an engine (not including gearbox) in a day?
>
Hey, I did it on a lunch break once!
Luke
'71 Spit Mark IV sans tranny for a few more days - shout out to Mike at
Obsolete Automotive for finding me a used reverse idler and 1st gear synchro
hub the day before Bronte and bringing them to the show for me to pick up!
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
|