Hi Avi
I think the end float you are talking about is for the distributor drive
gear. The float is adjusted by the addition of extra gaskets under the
distributor pedestal. I have sent the image on how to do this from the
Triumph Workshop Manual.
Hope this is clearer than the Haynes.
Graham,
1967 1300 FWD
1968 2000 Saloon
1972 2.5PI Saloon
1974 Sprinted Dolomite 1850
1975 Toledo in restoration!
http://www.triumph-iw.co.uk
http://www.mickdolphin.co.uk Spares Supplier.
----- Original Message -----
From: <A666K@aol.com>
Subject: Distributor Endfloat?!!!?
|
| Good Morning All!
| I took the morning off to see if I can get the new motor fired up. I am
| almost ready, I still need to install the distributor. My Haynes manual
goes
| through a whole process of setting the distributor's endfloat. I have no
idea
| what they are talking about. Can anybody give me a simple procedure on how
to
| do this? assume that my #1 cylinder is ready to fire. How do I measure the
| clearance they speak of?
| TIA,
| Avi
[demime 0.97c removed an attachment of type image/jpeg which had a name of
Image1.jpg]
///
/// spitfires@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe spitfires
///
///
|