I took the heater box out of my 1500 the other day and found the foam on it
crumble when touched. I looked in my catalog and the foam pieces were not
listed. I went to the hardware store and picked found a large sponge more
like a foam block that I think will work where the hole for the motor
mounts up to the car. Then for the foam on the two ports on the heater
core I found some hard foam that is put on pipes in your house that I can
cut shorter. Is there any problem with either of these two ideas? I think
that the sponge will work fine after I cut it down, but not sure of the
foam for the heater core pipes. Any help would be greatly appreciated!
Thanks.
Phillip
Phillip
metaz76@earthlink.net
http://home.earthlink.net/~metaz76
|