In message <000701c04685$35347980$271578cc@default>you write:
>
>My first try at rebuilding a ZS CD carb has resulted in a puzzling
>problem for me. I replaced all gaskets and the biased metering needle
>and bowl jet but when I start the car now it idles (!) at 2800 rpm with
>no choking or pressure on the accelerator. The idle speed screw is
>completely backed out so that's not the problem. I've pulled it off 3
Hi Gary check and see if the butterfly valve (throttle plate) is set
properly into the throttle. The valve in the fully closed position
should not let any air throught. To sit the valve properly, just
lossen the screws holding it and set it into place.
>Gary Hutton
>76 1500
Dave |\ | | |
_______________________________________/\ /\ /\_____| \|_____| |____________
Dave Chu \/ \/ | /| | |
Dept. of Elec. & Comp. Eng. |/ | | |
Concordia University Voice:(514)848-3115 Fax:(514)848-2802
1455 de Maisonneuve W. H961 Email:dave@ece.concordia.ca
Montreal, Quebec, Canada H3G 1M8 http://www.ece.concordia.ca/~dave/addr.html
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
|