PDWA is the pressure warning device.
The POS stands for Piece of S---.
-----Original Message-----
From: Richard B Gosling [mailto:Gosling_Richard_B@perkins.com]
Sent: Tuesday, October 17, 2000 2:46 AM
To: CraigS
Cc: npenney; spitfires
Subject: RE: What's wrong with my brakes?
So... What on earth is a POS PDWA valve? Too many initials that I don't
know
what they stand for!
Nolan - I had to push the pistons back in a little to remove the pads, in
order
to grind off the excessive metal. The moved quite freely, and re-applying
the
brakes should have pushed them back to the new correct position. No sign
of
any fluif loss around the pistons. So I doubt that is the problem.
In fact, driving home yesterday, I felt that the brakes HAD improved
somewhat
compared to how they were at the beginning of this saga. So, the grinding
of
the pads and/or the extra bleeding has helped. They are still not quite
where
I would prefer them to be, but good enough to lend Daffy to my wife while I
take her car in to have its suspension fixed (it's a Citroen, their
suspension
systems are way too complicated for their own good...). I'm hoping that
adjusting the rear brakes will be enough to get the brakes right back to
where
they should be, although I may still replace the rubber hoses with new,
steel
braided items, to improve response further.
I am confident the my front brakes are still working, at least after the
second
press, as they will lock up happily when hit hard. Also, if it was just
all
air in the system, I should hear it rushing out under 21 psi pressure from
the
tyre, not the complete lack of anything I got when I opened up the bleed
valve. It must be a blockage, which I will try to clear under pedal
pressure.
R & D
CraigS@iewc.com on 16Oct2000 08:05 PM
To: Richard B Gosling/1M/Caterpillar@Caterpillar
npenney@mde.state.md.us@INTERNET
cc: spitfires@autox.team.net@INTERNET
Subject: RE: What's wrong with my brakes?
Retain Until: 15/11/2000 Retention Category: G90 - Information and
Reports
Perkins Confidential: Green
I don't know if anyone has suggested this,,,,
It might be that POS PDWA valve !
If your getting nothing from the front bleeders it just might be that damn
thing
I suggest removing it and throw it as far as you can
|