In message <003701c00d74$26f17660$e54ab126@default>you write:
>
>Fellow Listers:
> I'm getting severe wear on the outside edge of the drivers side front
>tire. I've replaced all bushings with poly. The shocks are shot and need
>replaced but I don't think it would contribute to the problem that much. The
>trunnions are in good shape,bearings are too. It appears (that looking down
>on the tires) that the top of the tire is farther out than the bottom.
>There's no *excessive* play anywhere. Where do I go from here?
You should get an alingment after suspension work. Your car might
of have an alingment with the worn bushings, with the new bushings
that throws everything off.
Dave |\ | | |
_______________________________________/\ /\ /\_____| \|_____| |____________
Dave Chu \/ \/ | /| | |
Dept. of Elec. & Comp. Eng. |/ | | |
Concordia University Voice:(514)848-3115 Fax:(514)848-2802
1455 de Maisonneuve W. H961 Email:dave@ece.concordia.ca
Montreal, Quebec, Canada H3G 1M8 http://www.ece.concordia.ca/~dave/addr.html
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
|