In my experience, a decent pair of tin snips will
cut through Spitfire sheet metal.
Make a first cut 1/2" or so from the desired cut line, and
then trim the remaining bit.
Doug Braun
At 08:57 AM 7/10/00 -0500, you wrote:
>I plan to start working on removing my rusted out floorpan. I have a
>full pan for the drivers side and the cross member. What is the best way
>to remove an old own? I'd assume plasma cutter, but I don't have one
>available to me. What would be next best? Any other advise besides
>measure twice and cut once?
>
>Thanks
>Chris Pappathopoulos
|