Well the numbers don't match either of the ones listed
for the two port sizes, but my manifold has the short
depression between the runners. It does not run the full
length from carb to flange.
I don't have the number at hand but when I looked at it earlier
today, I know the number in the casting was not the same as either of the
two
previously listed.
Paul Tegler wizardz@toad.net http://www.teglerizer.com
-----Original Message-----
From: JeffreyLos@aol.com <JeffreyLos@aol.com>
To: spitfires@autox.team.net <spitfires@autox.team.net>
Date: Saturday, June 17, 2000 11:28 PM
Subject: 175CD2 carb and manifold
>
><As promised, here are the part numbers cast into the
>ZS manifolds I have:
>
>large port: V3178
>small port: V3796
>
>Thes numbers are cast into the bottom rear of the
>plenum, and can be hard to see when installed.>
>
>With the above information I can now report that the 175 on my 72 Spit has
>the V3178 large bore manifold. You can easily check your manifold to see
the
>number using a small mirror (or in my case a small piece of bright chrome)
>on the bottom left side.
>Jeff
>Portland, Oregon
>
|