Hi Jason
Do you have the rebuild kit to hand? if you do have a look at the bits, I
suspect you will find that the dust cover is an all rubber job, if it is the
best (and in my experience only) way to remove the cover is to split it open
with a screwdriver using a sort of twisting motion. If your dust cover is of
the same type as the original I would expect to find the new steel retainer
in the kit anyway.
Graham.
2500PI MKII
Sprinted Dolomite
2000 MKI
Toledo
1300 Front Wheel Drive
http://members.tripod.co.uk/TriumphIW/index.html
----- Original Message -----
From: Jason K. Cullum <jcullum@chorus.net>
To: Spitfire <spitfires@autox.team.net>
Sent: Monday, May 29, 2000 5:07 PM
Subject: Slave cylinder Question
>
> I am in the process of rebuilding the slave cylinder on my 63 spit MK1. I
> cannot for the life of me get the dust cover retainer off. It is stuck on
> there good. I have tried it all except heat. Any one experience this? Any
> advice would be greatly appreciated. Will heat warp anything?????
>
> Thanks,
> Jason
>
|