While re assembling my spring/diff which did not have a rubber pad, I found a
scrap of heavy duty rubber at suppler (forget where). Cut it to fit the width,
then decided how long to make it. I reckoned that if it was too long - ie as
long as the box on the top of spring it would be too long and prevent some of
the "roll" the setup was designed for. So I just cut it about half the length,
centered it over the bump in the top leaf and clamped it together. Hoping it
works good enough.
Cheers, Fred
Alan Black wrote:
> but how
> important and what can be used to replace the rubber pad/button that goes
> between the top leaf and the bracket on the very top of the spring. Mine is
> thrashed from 23 years of being on the car,
--
Fred & Wendy Griffiths,
Calgary, Canada
http://www.cadvision.com/griffco/index.htm
mailto: griffco@cadvision.com
|