For the benefit of all interested:
The seat type is a RECLINING bucket, cloth, with high wear areas covered in
thick leather. It is avail. w/ or w/o shulder strap passages.
I am not asking anybody to order anything, I just need the dimensions
previuosly requested (see below+seat hight) in order for the manufacturer to
create a "prototype" which will be my seats. If all goes well (fit, etc), I
will post some pictures, and whoever is interested can order them directly from
the manufacturer.
As far as cost goes, I have no figures yet, but they will be cheaper then
reclining bucket seats in the states, and appear to be of greater quality.
thanks,
Avi
> In a message dated 02/21/2000 3:29:28 PM Eastern >Standard Time,
>A666K@aol.com writes:
>
> Hey all!
> I know that a bunch of us through the last couple of >years were talking
>about converting to bucket/racing >seats. I might have a couple of possible
>surcesI am >far away from my car and can not get dimensions off of >it, so
>this is where you all come in. I need the >following info (part/complete):
> 1.Bolt pattern in floor board(L/W/dist. from >back&side)
>
> 2.Bolt pattern in the seat (where the seat rail >bolts to it.
>
> 3.Any other limiting seat dimensions you can think >of.
>
> This is for a 1500, I dont know if it varries b/w >the models. If this works
>out well, how many of you >would be interested in such a swap? please mail me
>>privately, the list as a whole does not need to be >bothered with this.
> Thanks.I.A
> Avi&Cheech the ´78 far away Spit
>
|