Barry,
Thanks. My concern is whether it will still leak or not - Graham
mentioned in his reply to peen the ends of the shaft, or the pump body
over the shaft... but will it still leak?? Inquiring minds want to
know! %^)
Peter
- - -
Barry Schwartz wrote:
>
> < snip >
>
> Interestingly, I have the same problem with the GT6 (glass dome type) fuel
> pump. The small lever fulcrum pin is where the leak is. On mine there are
> little circlips on each side that hold the pin in, being only a slip fit.,
> and the only way I could see to seal it was to make a slightly larger pin.
> Then PRESS it in with Loc-tite, using the circlips as a backup just in case
> it were to ever loosen. I haven't done this yet, but one of these days I
> will. . . unless of course, someone else comes up with an easier way to do
> it-
|