In a message dated 9/22/99 3:11:49 PM Eastern Daylight Time,
bschwart@pacbell.net writes:
<< If this car never had O/D then you will need to cut a section out of the
tunnel of the floor about 6 inches back to accommodate the overdrive unit,
and either fabricate or obtain a cover for this cutout area. Don't feel
bad, this is exactly what the factory did to install an overdrive in a
vehicle slated for one, so your not "butchering" it. >>
Hey Barry,
I am not too clear about the modification to the car for the O.D.. Let me
know if I got it right. The metal part of my transmission tunnel needs to be
cut further back then where it currently ends, so that it can accommodate the
O.D.. Did the O.D. cars have a different cardboard trans cover? If not was
there some sort of intermediate cover?
Thanx a lot for all your help.
Avi
|