Do you really need to disconnect the ball joints (I assume you mean the tie rod
ends)?
Can't you simply unscrew the tie rod from the tie rod end while the tie rod end
is still
in place? You have to remove the tie rod end form the tie rod any to get
the bellows on, right?
Doug
'72 Spit.
>> I am about to replace both steering rack bellows and I am looking for tips
>> to do the job properly and smoothly.
>
>I just replaed a set on a 1500 I'm restoring. It was not difficult I would
>say you do
>NOT have to lift the road wheels off the floor.
>
>After loosing the ball joint nut, a good smack with a hammer on the side of
>the steering
>arm usually does loosen the tapered bolt.
|