Ryan,
If the misalignment is front to back rather than side to side, you can adjust
the steering column a little by moving the wheel closer or further from the
dash. I had the same problem when I had to remove my steering column. After
I reinstalled it, my tonneau did not fit right. It just took a little
adjustment. I don't remember the exact procedure, but its pretty strait
forward. I think there are a couple of U shaped brackets that secure the
column and keep it from moving. If you loosen them up a little the whole
column will move front to back. When you get it where you want it, just
tighten them back up and try the cover for fit.
David Gates
'73 Spit 1500
'78 Spit 1500
Hawaii
http://members.aol.com/gatesdavid/index.htm
In a message dated 9/24/98 2:47:01 PM Hawaiian Standard Time,
shmitty99@hotmail.com writes:
> 2nd question today is about tonneaus. I just recieved my used tonneau
> today and I put it on the car. It fit fairly well. It was a litte
> tight but I got all the snaps to go on (the car already had the snaps
> and dash mounts in place). The thing I noticed was that my steering
> wheel didn't line up in the slot. I think this tonneau was from a 76.
> Were the steering wheel alignments that different? Just curious.
>
|