I'm in the process of replacing my main brake lines
that run from the front to back of car. I'm using the
standard fittings on the ends and the adapters so I
can use standard flare connections. I did purchase
one of those tools to do the double flare. I could
not get a good seal at either end. I then re-did it
and used a standard flare and still have leaks. Are
there any special tricks to getting a good seal at the
fittings?
Thanks for your thoughts.
Mike
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|