Re: [Shop-talk] soldering/brazing aluminum tubing to steel tubing

[David Hillman via Shop-talk <shop-talk@autox.team.net>]

    Interestingly, here is another version of pretty much the same chart... 
except this one says "No" to brazing aluminum and "carbon & low-alloy 
steels".

<https://vacaero.com/wp-content/uploads/2017/03/Table-2-lg.gif>

    Source: AWS Brazing Handbook (Fifth Ed, 2007, p 75)

    As mentioned, rubber or silicone hoses would seem like a much better 
solution.


On Wed, 19 Dec 2018, Bob Spidell via Shop-talk wrote:
> 'Modern Welding' 11th ed.
>
> On 12/19/2018 9:13 AM, john niolon via Shop-talk wrote:
>> does anyone know if there is an acceptable way to braze or solder aluminum 
>> tubing to steel tubing that
>> will provide a strong, waterproof, low pressure? (30 psi r less) 
>> connection...? materials to use ??? particular
>> braze rod or solder ???
>> this will be for heater hoses on my truck engine... 5/8? tubing to same 
>> sized steel fitting
>> thanks
>> john
>> 
>

--
  David Hillman
_______________________________________________

Shop-talk@autox.team.net
Archive: http://www.team.net/pipermail/shop-talk