This is a multipart message in MIME format.
--===============5661065306193518514==
This is a multipart message in MIME format.
--=_alternative 0065C0A285258362_=
I'm making a piece of furniture that needs to have a rounded 'dish' cut
into it. Like a cove cut on a board, but just in a circle. Think of a
change plate where there is a bowl cutout on a board.
The cut would look like if you had a table saw blade about 1/2" out of the
table, then put a piece of wood straight down on it and twisted it in a
circle. I know that wouldn't work (and would be HUGELY unsafe.)
Here is an image of the cut I am trying to make (there are two of them on
this valet..
https://www.etsy.com/listing/229799235/mens-valet-mens-valet-change-dish-modern
Anyone know how to do that? I can only find ways to make a cove
lengthwise in a board. The piece isn't small enough to put in a lathe
(but I thought about making an insert, and that is my last resort, but I
would rather not do that.)
Thanks in advance!
Sent from my Commodore 64 on a 2400 Baud Modem.
Tech Viper
"Be as beneficent as the sun or the sea, but if your rights as a rational
being are trenched on, die on the first inch of your territory." Ralph
Waldo Emerson
--=_alternative 0065C0A285258362_=
<font size=2 face="sans-serif">I'm making a piece of furniture that needs
to have a rounded 'dish' cut into it. Like a cove cut on a board,
but just in a circle. Think of a change plate where there is a bowl
cutout on a board.</font>
<br>
<br><font size=2 face="sans-serif">The cut would look like if you had a
table saw blade about 1/2" out of the table, then put a piece of wood
straight down on it and twisted it in a circle. I know that wouldn't
work (and would be HUGELY unsafe.)</font>
<br>
<br><font size=2 face="sans-serif">Here is an image of the cut I am trying
to make (there are two of them on this valet..</font>
<br>
<br><a
href="https://www.etsy.com/listing/229799235/mens-valet-mens-valet-change-dish-modern";><font
size=2 color=blue
face="sans-serif">https://www.etsy.com/listing/229799235/mens-valet-mens-valet-change-dish-modern</font></a>
<br>
<br><font size=2 face="sans-serif">Anyone know how to do that? I
can only find ways to make a cove lengthwise in a board. The
piece isn't small enough to put in a lathe (but I thought about making
an insert, and that is my last resort, but I would rather not do that.)</font>
<br>
<br><font size=2 face="sans-serif">Thanks in advance!<br>
<br>
Sent from my Commodore 64 on a 2400 Baud Modem.<br>
Tech Viper<br>
"Be as beneficent as the sun or the sea, but if your rights as a rational
being are trenched on, die on the first inch of your territory." Ralph
Waldo Emerson </font>
--=_alternative 0065C0A285258362_=--
--===============5661065306193518514==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
Shop-talk@autox.team.net
Archive: http://www.team.net/pipermail/shop-talk
--===============5661065306193518514==--
|