Given your numbers below - tubing ID comparable to 3/4" fitting ID - I
recommend fitting either a length of 3/4" inside the existing line
(after prepping both for soldering) or using a street fitting. Should
solder up just fine.
Regards,
Mark Miller
markmiller@threeboysfarm.com
On 10/20/2018 8:01 PM, shop-talk-request@autox.team.net wrote:
> I mic???d the tubing and the fitting and here???s the results
>
> tubing i.d. is .882??? which is just over 7/8???
> tubing o.d. is .900??? which is just under 29/32???
>
> a new standard Tee i.d.is .876??? which ain???t gonna fit over .900
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/pipermail/shop-talk
Unsubscribe/Manage:
http://autox.team.net/mailman/options/shop-talk/mharc@autox.team.net
|