shop-talk
[Top] [All Lists]

Re: [Shop-talk] Power Washer engine question

To: shop-talk <shop-talk@autox.team.net>
Subject: Re: [Shop-talk] Power Washer engine question
From: Paul Parkanzky <parkanzky@gmail.com>
Date: Mon, 19 Oct 2009 14:17:34 -0400
We use ultrasonic baths in the laboratory to clean delicate equipment
with very small nozzles and apertures.  We also use them to dissolve
barely soluble solids to make standard solutions.  I've always wanted
one for home and I think that it would be great for all kinds of
cleaning, especially something like a carb.  I just can't justify the
cost of one that I think would be big enough.

Simple Green seems to me like a good choice for a detergent to start
with.  You can also sonicate in organic solvents and that might work
better with a gummed up carb.  To use solvents sparingly, you can fill
the bath with water and then put a glass container just big enough to
hold what you are cleaning (like a jet or other small bit) full of the
solvent of choice in the bath.  You'll have to find a way to anchor it
in the bath because it will be uncomfortable to hold onto for more
than a couple of seconds.  For something as big as a carb though,
you'll likely be better off just filling the bath unless the bath you
have is huge.

Also, if your bath doesn't have a heater I would recommend using hot
water/solvent.  It makes a huge difference.

-Paul

On Mon, Oct 19, 2009 at 1:44 PM, Elton E. (Tony) Clark
<eltonclark@gmail.com> wrote:
> *I have a ultrasonic unit originally made for watchmakers and jewelers.
 The
> person I got it from used common detergents like "Simple Green" so that's
> what I use.  It does a good job on carburetors and other gum up problems
but
> I wish I knew more about which solutions and  which frenquencies are best.*
> *Tony in Texas*
>
> On Sun, Oct 18, 2009 at 4:47 AM, nick brearley <nick@landform.co.uk> wrote:
>
>> David C. wrote:
>>
>>> What Ben said.  Classic example of a plugged main jet or the fuel passage
>>> to the main jet.
>>>
>>> Has anyone experience of ultrasonic carb cleaners? I have a similar
>> problem with a lawn mower engine (Kubota) that was parked for several
years
>> with the same results. Carb cleaner and soaking in cellulose thinners made
>> no difference although it will run on straight carb cleaner sprayed into
the
>> intake. The carb is a Nikki which is like no carb I've seen before.
>> Ultrasonic seems to be the next step but any personal experience would be
>> valuable.
>>
>> Thanks.
>>
>> Nick Brearley
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


Shop-talk mailing list

http://autox.team.net/mailman/listinfo/shop-talk

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>