[Top] [All Lists]

Re: [Shop-talk] Basic MIG Welding questions

To: "Doug Braun" <>, "Shop Talk List"
Subject: Re: [Shop-talk] Basic MIG Welding questions
From: "Arvid Jedlicka" <>
Date: Tue, 3 Feb 2009 07:05:17 -0600
My Lincoln PowerMig 300 doesn't have a purge setting but it does have 
preflow - two seconds of flow before the wire feeds - so by setting the wire 
feed down as far as it will go and pulling the trigger and then releasing it 
after a second - repeat four or five times - the plumbing is purged - I get 
to double check the flow on the gauge - and either zero or very little wire 
is wasted. 
Support Team.Net

Shop-talk mailing list

<Prev in Thread] Current Thread [Next in Thread>