Please Note: I have never tried this!!!!!
That being said, I would see if I couldn't buy a DADO blade and put it on
a circular saw. Adjust it to a controllable width and the cuts would be
quick.
Just my thought.
GPD4
On Thu, 4 Sep 2008 13:12:31 -0700 (PDT) Obaa <obaa996@yahoo.com> writes:
> Hi all,
> I have a set of 2x6 rafters (25) that I need to notch for some 2x2
> purlins. There are 6 purlins per rafter, so a lot of notching....
> The only way I'm aware of to make these notches is to saw a number
> of closely spaced slots, then knock out the "fingers", and use a
> chisel to clean up the groove.
> Is there a better way to do this, given the number of notches
> required? I have just basic hand and power tools (circ saw, jigsaw,
> router); no table saw or anything else like that. Any ideas
> appreciated!
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as gpd4@juno.com
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive
>
>
____________________________________________________________
Click here to save cash and find low rates on auto loans.
http://thirdpartyoffers.juno.com/TGL2141/fc/Ioyw6i3ndyHoQmZUNDfBzBGWrKekurBg9vEczTZnC2SlT5SKjXZrqW/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|