Obaa wrote:
> I'm trying to build a small rack/platform using some 5/8" round tubing.
> I'm planning for it to be rectangular, with the tubes cut at a 45 degree
>angle (don't have a tubing bender). I'm going to notch 3 crossbars with a
>5/8" drill, to form a nice, flat platform.
> The problem is, I don't know how to align the tubing to keep all the cuts
>square with each other. Is there a simple way of doing this?
I've seen racing supply catalogs and ads in Grassroots Motorsports
peddling fixtures to cut & drill pipe ends for roll cages and stuff.
Not sure about welding fixtures, but if such a thing exists, the same
places would probably have it. SummitRacing.com has darn near
everything and ships quickly.
-Wayne
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|