shop-talk
[Top] [All Lists]

Re: HF Dual MIG Welder

To: doug@dougbraun.com, shop-talk@autox.team.net
Subject: Re: HF Dual MIG Welder
From: "JAMES STONE" <jandkstone99@msn.com>
Date: Sat, 25 Mar 2006 21:06:55 -0600
Thanks, Doug.  HF sells one that a 120 volt unit that is almost identical, 
but I have a 220 line in my garage, so I figured I might as well go for the 
higher voltage.


>From: Doug Braun <doug@dougbraun.com>
>To: JAMES STONE <jandkstone99@msn.com>, shop-talk@autox.team.net
>Subject: Re: HF Dual MIG Welder
>Date: Sat, 25 Mar 2006 16:49:51 -0800 (PST)
>
>Reading the maiual from the HF web site, I noticed:
>
>1:  It's 220 volts, but I'm sure you know that.
>2:  It has a rather crude power output control, with
>     two toggle switches.  It might be a hassle getting
>     the right power level to weld thin sheet metal
>     well.  I have a Lincoln SP125, which has a
>     electronically-controlled continuously-adjustable
>     power level.  But I really splurged when I got it.
>3:  The tip is probably hot whenever it is turned
>     on, even when you let go of the trigger.  This
>     means you have to be careful where you put down
>     the torch.
>
>But I agree, it's cheap.  BTW, I have never been
>limited by my unit being 120 volts.  I can do 1/8"
>no problem.  You just need a good, honest 20 amp
>outlet.
>
>Doug Braun
>
>--- JAMES STONE <jandkstone99@msn.com> wrote:
>
> > Harbor Freight currently has a dual MIG for sale.
> > It would allow me to work
> > with or without gas, and at $200 it is in the
> > ballpark of what I wanted to
> > spend.  Does anyone have any experience with this or
> > similar setups?  Is it
> > a good 'starter'?
> >
>

_________________________________________________________________
FREE pop-up blocking with the new MSN Toolbar  get it now! 
http://toolbar.msn.click-url.com/go/onm00200415ave/direct/01/




<Prev in Thread] Current Thread [Next in Thread>