> Any sources for an inexpensive one of these?
> My local shop wanted to sell me a Stant setup
> for $100. I figured I could do better online -
> turns out that's the cheapest by far! JC Witless
> and Northern Tool want considerably more...
On my TR3A, I took out the plug where the heater valve goes, and installed a
plumbing tee with a fitting on one side for my vacuum gauge (which reads to
10psi pressure), and a Schrader valve on the other side. That allowed me to
test all the components in unison, and prove that the cap was not holding
pressure. After fixing that, I left it pressurized overnight and checked
for leaks the next day.
Randall
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|