Re: separating aluminum and steel parts

["Tony Clark" <lotus.tony@airmail.net>]

Herbert Tobin's response to this problem exemplifies what is wonderful about
this list:  contributors who've "been there, done that"  and will take the
time to give full and complete information on a solution.

   Gawd, I love this list!

Tony

> The technique that worked for me was to rotate each stud
>clockwise and counter clockwise until the corrosion between the head and
the
>studs broke up. To rotate the studs I used Snap-On part CG500-2, a stud
>removal collet holder   snip   snip.