Thanks for all the info b checked out web sites b not available. With
these vacuum hose fittings and their different I. D.bs on each end Ibve
decided to make up some b elbow using bent copper tubing / solder expansion
section on larger end with clamped rubber hoses on each end. Straights using
largest I. D. hose coupler & clamping to larger & smaller ends.
Hope it works,
Jim
From: thomasind@nventure.com
Sent: Tuesday, January 07, 2014 3:38 PM
To: oletrucks@autox.team.net
Subject: GM LT-1 Engine Parts
Have a 1994 GM 5.7 LT-1 engine in my 55-1st p u. Looked everywhere for some
of the engine vacuum line fittings like in & out of the EVAP Solenoid that are
a 90 & straits with two different I Dbs. Anyone have any suggestions?
Thanks,
Jimend
_______________________________________________
Oletrucks@autox.team.net
Archive: http://www.team.net/archive
|