Thanks Mark. I have the 4 speed installed now - anyone know if that is that
the same length as the 3 speed? Bob
-----Original Message-----
From: oletrucks-bounces@autox.team.net
[mailto:oletrucks-bounces@autox.team.net] On Behalf Of mark@noakes.com
Sent: Sunday, December 11, 2011 1:03 PM
Cc: oletrucks@autox.team.net
Subject: Re: [Oletrucks] 3 speed overdrive conversion
I happen to have the 3-speed out of my 58 Suburban stored next to the
3-speed OD I plan to put back into it. As far as I can tell, they are
identical in length, 22 inches from trans-to-bellhousing mount to end of
tail piece plus 1/2 inch out the back for the splines on the shaft.
Mark N
58 Chevy Suburban, 2wd, V8 3-speed OD if I ever get it finished
58 GMC 1/2 ton big back window short bed wideside, NAPCO 4wd, 4-speed,
270 6, orig power steering
On 12/11/11 3:29 PM, Robert Swanson wrote:
> I have a 3 spd overdrive from a 1/2 ton (55-59), and it looks to be
the same
> length as the standard transmission. I don't have a regular non overdrive
> tranny to confirm the measurements. I have a parts book and will look to
see
> if the driveshaft for the overdrive is a different part number.
> If someone does have the length of the talishaft for the non
overdrive
> transmission, it will be easy for me to confirm whether or not the
driveshaft
> length will have to change. I don't think it does.
> If you don't have the parts for the column shift, I would just use a
floor
> shift. Old column shifters can be a pain to get set up properly.
> The transmission freewheels when it is in the overdrive mode.
> Bob
_______________________________________________
Oletrucks@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/oletrucks/kinderlehrer@comcast.net
_______________________________________________
Oletrucks@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|