On Jan 3, 2011, at 9:08 PM, Kent S. Butler wrote:
Fellow Ole Truckers:
I am getting ready to start the process of work on the front end of my '56
Chevy 3100. One item of attention, is the tie rod and ends. I will be
replacing with the new style tie rod ends. I have read the various tech
articles and it seems pretty straight forward. Grind off the peening, drill
hole in center and drive out old ball stud. Will see how easy or hard it
really is.
Just seeking any do's / dont's or tips on the process before I dive into it.
Thanks again for any input.
Kent S Butler
'56 Chevy 3100
Houston, TX
-----------snip----------
Heat will make the job much easier. Heat the part with the hole in it, not the
ball. Then be prepared to smack it and it should pop right out. No need to
drill the hole if you do this. The object of the hole is to keep the tapered
part from swelling while you beat on it. If you apply plenty of heat
(oxygen/acetylene torch) to the part with the tapered hole, the ball will pop
out with one good lick.
I did this years ago. My current truck ('54 3100) still has the original joints
and I'm OK with that.
Gale Gorman
Houston
_______________________________________________
Oletrucks@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|