I need a little help with an electrical problem. Accidentally pulled some
wires loose while replacing a speedometer cable on the '50 3600, and now I
am not getting fire when I try to start the engine. My "ignition switch"
has a terminal for the battery and one for accessories. I do not use the
ignition terminal because the starter pedal is on the floor.
So I have 2 ignition switch terminals to hook up wires to so that when I
turn on the key a circuit is closed and I get fire when I start the engine.
One terminal has a hot wire from the battery. That one is hooked up. The
other one has accessories such as blinkers, gas gauge, radio etc. They all
work when I turn the key on. I am not sure where the missing wire comes
from, but I would think from the distributor or coil (?).
Thanks for your help!
Smokey
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
Oletrucks@autox.team.net
http://autox.team.net/mailman/listinfo/oletrucks
|