I'm about ready to take my Panel's running boards to the Rhino-lining place
and came upon a question....
There's a square hole in each running board....I believe these are for a
brace that supports the rounded "sheet metal filler" beteeen the bedside
and running boad on pickups. I plug welded them on my pickup and went
without the brace (is it needed??)
Question comes: Are these holes required for the (1/2-ton) Panel?? Is there
a similar brace (my assembly book is across town). I'll probably fill them
anyway but I though I'd ask....
And while I'm asking....what do folks use to restore the like-new appearance
of Rhino-lining??....Armor-All?
Any/all help appreciated....
-A
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|