the AD trucks are setup for a straight 6 motor, you'll have plenty of room
for a SBC with a long pump. your problems will be motor and exhaust
clearance around the steering box. a new xmember with rack & pinion steering
will fix this.
Kurt
58 3100 Apache project
the "Duracell Project" it keeps going... and going...
>From: "Bob Chansler" <rchansl@attglobal.net>
>Reply-To: "Bob Chansler" <rchansl@attglobal.net>
>To: "'Oletrucks'" <oletrucks@autox.team.net>
>Subject: RE: [oletrucks] Crate Motor Installation
>Date: Wed, 26 Oct 2005 07:26:00 -0600
>
>I am in the process of putting a 400 small block in my AD suburban. Am I
>going to need to change to the short water pump to get this to use the
>mechanical fan? If I do change, do I have to change all the pulleys and
>brackets too?
>Thx,
>Bob Chansler
>Mead, CO
>
>-----Original Message-----
>From: owner-oletrucks@autox.team.net
>[mailto:owner-oletrucks@autox.team.net] On Behalf Of K Ohlgren
>Sent: Monday, October 24, 2005 10:41 AM
>To: Dennis.McGillis@mcgilliscompany.com; oletrucks-digest@autox.team.net
>Subject: Re: [oletrucks] Crate Motor Installation
>
>
>sounds like your problem is with the accessories? the motor probably
>came
>with a long water pump, if you swap it out for a short water pump
>everything
>should bolt in with the stock mounts. carcraft installed a GMPP motor in
>a
>65 and had similar problems that were fixed with a new waterpump
>http://www.carcraft.com/howto/56398/ read the article. I'm currently
>fabricating new brackets for my crate motor, I feel your pain. acces
>brackets are pricey for the stamped metal ones and ludicris priced for
>anything else.
>
>Kurt
>58 3100 Apache project
>the "Duracell Project" it keeps going... and going...
>
>
>
>
>
> >From: <Dennis.McGillis@mcgilliscompany.com>
> >Reply-To: <Dennis.McGillis@mcgilliscompany.com>
> >To: "K Ohlgren" <kjohlgren@hotmail.com>,
> ><oletrucks-digest@autox.team.net>
> >Subject: Re: [oletrucks] Crate Motor Installation
> >Date: Sun, 23 Oct 2005 10:38:49 -0700
> >
> >Hi Kurt,
> >This new GMPP 350 crate motor is going in my '65 Chevelle but the
> >accessory
> >mounting problems would be the same if it was going into my '55 Cameo.
>I
> >visited Danchuk yesterday www.danchuk.com (they do 55-57 Chevy and
>Chevelle
> >parts) and found aftermarket brackets which look like they will cure
>the
> >problem. I'll know for sure when I start assembling it.
> >Thanks,
> >Dennis
>
_________________________________________________________________
Is your PC infected? Get a FREE online computer virus scan from McAfee.
Security. http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|