Finally after 5 days of soaking in PB, a four foot crow bar, and a
slide hammer I got the darn bearings and seals out! But when the
bearings came out a washer wich was behind the bearing came out also
but the washer is all bent up. I hammered it flat but now it wont fit
back into the axle housing and when I got my new bearings they didnt
come with a new washer. Is this washer neccesarry? and if so would the
local auto parts store sell them? or could I get away with grinding
down the outside and inside of the washer to make it fit?
thanks for all the help
luke
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|