well my crate motor arrived from GM last week. I bit the bullet and bought
GM's Ram Air 350
http://www.goautocenter.com/350%20ram%20jet.htm
installed it to make sure everything would match the old 350 installation.
the motor fit but there are 2 plugs that go into the back of the electronic
ignition distributor. I tried to move the motor forwards but ran into oilpan
interference. any one install this motor in a Task Force pickup yet? it
looks like I will need to move the hump in the firewall back about an 1 1/2
inches to get clearance for these plugs.
Kurt
http://bulldogaquaticclub.com/dloads/pu/truck.htm
_________________________________________________________________
Check out Election 2004 for up-to-date election news, plus voter tools and
more! http://special.msn.com/msn/election2004.armx
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|