In a message dated 10/5/2004 4:42:23 AM Central Standard Time,
wayne@chevytrucks.org writes:
when mounting the master cylinder on the bracket, appears this would move the
entire unit to the rear quiet a bit. How do you handle adding fluid as it
appears it may be past the hole in the floorboard for adding fluid. What
ingenious methods do
Wayne,
You are right, the MC no longer lines up with the factory hole in the
floor. I use a small plastic funnel with a short length of hose shoved over
the
end. Adding small amounts of fluid and then looking to see the level will get
the job done. I just didn't want to cut the floor.
Mike Klepp
'48 3100 5 window
'65 C-10 stepside
Wichita Falls, TX
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|