[oletrucks] King Pin Locking Pin

["Larry Burnett" <larburnett@cox.net>]

I'm finally getting around to replacing my king pins, and have run into a
little delemna.  Not sure if someone had tried before, but on the drivers
side, the locking pin is sheared off, leaving me nothing to strike and drive
it out.  

I'm guessing that nothing shot of a brass drift, lots of heat ad a good deal
of patience will do anything, unless any of you have other suggestions?  

-Larry

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959