We are using the por15 on my sons 60 belair. We cleaned and used por 15
metal prep and looks good and plan on putting on back sides of fenders.
----- Original Message -----
From: "Wayne" <wroworth@tampabay.rr.com>
To: "oletrucks list" <oletrucks@autox.team.net>
Sent: Friday, October 24, 2003 7:23 AM
Subject: Fw: [oletrucks] a few POR 15 questions
> I am doing my doors down to bare metal and would love to hear some prep
> suggestions as well.
>
> Wayne - '47 1 Ton Panel
>
> ----- Original Message -----
> From: "Tom C." <c_tom@bellsouth.net>
> To: "Oletrucks" <oletrucks@autox.team.net>
> Sent: Friday, October 24, 2003 6:04 AM
> Subject: [oletrucks] a few POR 15 questions
>
>
> > Would it be ok to use POR 15 on the inside of the backing plate where
the
> > brake shoes are mounted?
> > Also if I use POR 15 on bolts (such as the bolts that hold the axel on
to
> > the backing plate) would that ruin them or will they still go on and off
> > when needed?
> > One more thing...I am using a wire cup brush to clean the rear end and
it
> is
> > doing a good job. POR 15 manufacturer says to use their metal prep if
all
> > the rust is removed to the metal, has anyone used another metal prep
with
> > any success?
> > Thanks for all the help
> > Tom
> > 55 2nd
> > 97 S-10
> > oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|