When I bought my '55 1st it had a rear end I was told came from a Jeep
Wagoneer. It was six lug and fit my AD truck just fine. It was a Dana 44 I
think, but finding one the right width and lug pattern would be the trick.
----- Original Message -----
From: "William Schickling" <wschick1@twcny.rr.com>
To: "Pat Cossey" <ccossey@seark.net>; "Oletrucks" <oletrucks@autox.team.net>
Sent: Thursday, October 23, 2003 5:04 AM
Subject: RE: [oletrucks] Rear end to fit Art Deco?
I am putting a 19551st 1/2ton rear end in my 1940. The rear end will fit on
top of the springs and is only 1 inch wider on each side. It is practically
a bolt in. It has 6 lugs and open drive line. Of course they were only made
for 6 months and they are hard to come by.
I am not 100% sure but I think 19552nd and after the axle rode under the
springs and not on top. Maybe you can flip it over and run it on top.
Bill Schickling
-----Original Message-----
From: owner-oletrucks@autox.team.net
[mailto:owner-oletrucks@autox.team.net]On Behalf Of Pat Cossey
Sent: Wednesday, October 22, 2003 9:50 PM
To: Truck list
Subject: [oletrucks] Rear end to fit Art Deco?
I`m sure at some point this has been covered,But what rear end will fit
under
my 41 and still have the 6 lugs?
Iv`e been told some of the early to late 60`s chevy trucks may have one that
will work?
Thanks guys!!
Pat 67 Nova SS
41 Art Deco chevy truck
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|