In a message dated 6/22/03 7:31:43 PM Pacific Daylight Time,
jforbes2@mindspring.com writes:
> , what's the procedure for
> >filling these holes.
well, im not a welder, but i have watched a 2 friends of mine fill
holes.....first you get a scrap of plate copper thin enough to bend to the same
body
contour as area with the hole...place the copper behind the hole.then he uses
an
electric welder that feeds wire automaticly.no plug is needed ,the molten
wire wont stick to the copper just fill the area with weld.remove the copper
plate grind and finish as usual...again im not a welder,but those of you who
are
check into this procedure ,my friend swears by it....steve
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|