Well said! However, I happen to be a big fan of the torque tube set up.
It's a lonely place sometimes...
Allen in Seattle
'50 3100
----- Original Message -----
From: "Jack Halton" <safesix@earthlink.net>
To: <oletrucks@autox.team.net>
Sent: Friday, September 27, 2002 6:03 AM
Subject: [oletrucks] Bad Advice - U-joint failure
Anyone who advocates removing the crossmember does not understand the role
played by all the components in a closed driveline system. The crossmember
not
only supports the tranny but stiffens the chassis. I would be very leery of
accepting advice from this dealer, including the one about drilling U-joint
bolts for wire. The lock plates work fine as long as they're replaced
anytime
the U-joint is disturbed.
I'm no great fan of the torque-tube but it is a very practical design and
has
some very good advantages. The problems arise when parts wear out after 50
years, maintenance is neglected, or past owners have kluged repairs.
Jack
www.inliners.org
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|