> In the shop manual for a 57 Chevy truck, the points gap at .019 new and .016
> used. (honest it says that) 6 cyl times at TDC and the V-8 at 4 BTDC. The
> book says .006 hot on the Intake valves and .018 hot on the exhaust valves. I
> could not find a dwell setting for the 6-cyl. Good luck
Greatly appreciate it. .019-.016 would put it right in the range of 30 degree's
(in case anyone else was wondering). I much prefer using dwell
when adjusting points, way more accurate. I'm sure that was a hard
to come by tool back then....
Thanks again.
Ryan
rlangford@attbi.com
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|