My local paint shop talked me out of chassis black and recommended acrylic
urethane. My friend, a body man, agreed. They both said I'd get a better
finish, would last longer and would be easier to touch up if necessary. I
haven't shot it yet and I am no expert by any stretch, just passing on what
I've been told. You know what opinions are like. Everyone has one.
----- Original Message -----
From: "Larry Jones" <lajones48@4edisp.net>
To: <oletrucks@autox.team.net>
Sent: Sunday, August 04, 2002 1:50 PM
Subject: [oletrucks] Frame paint
> I am finally starting to reassemble my 57 !/2 ton Chevy/Napco. I
> sandblasted the frame and was planning to use Eastwood's Chassis Black,
but
> even they admit that it's pretty finicky stuff. I am tempted to use
Rustoleum
> since I've used it before on other outdoor equuipment and it has lasted
> forever. Any other low tech ideas? Thanks.
>
> Larry Jones
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|