I've got one of those smaller compressors right now $400 a few years ago,
a claimed 5 hp (not true) and enough CFM to run my tools with a 30 Gal.
tank and it is not enough! I'll start cutting something and within about 1
minute my compressor kicks in and I run out of air in about 2 min... it
really sucks. They may have enough CFM @ xPSI to run your tool, but it
sure doesn't last very long.
-alfie
On Wed, 12 Dec 2001, Duncan M. Nickles wrote:
> I have been reading all of the recent postings about air compressors and shop
>set up. I have the impression that those of you with the large compressors
>are running more that your average shade tree garage.
>
> I too have been contemplating a compressor but am on hold until the funds
>materialize (or quit disappearing at least).
>
> I have been looking at the CFM displacement rather than the psi rating,
>etc... but the large compressors that have been discussed lately seem to be
>overkill for typical handy man activity. If I go to Sears, Home Depot, or
>Lowes and but a small compressor - less than 200 psi with a relatively small
>tank - less than 50 gal. - the CFM ratings are still there that I can run
>impacts, wratchets, die grinders, drills, sanders, paint guns, etc... I am
>not planning on running hydraulic lifts or anything of that industrial nature,
>but I may look at some small scale sand blasting in the future. I also will
>use the compressor for pneumatic nail guns in the shop.
>
> Am I missing the boat? I definately cannot afford a $750 - $1000 compressor
>(probably for the next 20 years). But I can afford $300 - $400 for one from
>Sears, Home Depot, or Lowes. Will I be disappointed? I realize that the
>compressor will run when I am using high demand tools like sanders, drills,
>and die grinders.
>
> Thanks
>
> Duncan Nickles
> Canonsburg, PA
> '59 Chevy 1-ton
> '75 Jeep CJ
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|