Hi Barret I may have a solution I have a rolling panel Chassis that may have
just what you need
Give me a call 1-208-409-3213
----- Original Message -----
From: "Barrett Revis" <snappydog@jackass.net>
To: <oletrucks@autox.team.net>
Sent: Sunday, September 09, 2001 2:28 AM
Subject: [oletrucks] Running board brackets
> There's a part I never see in the catalogs, ebay, or at the swap
> meets: the brackets riveted to the frame that the running boards set
> on top of, referred to in the assembly manual & parts book as "step
> hangers".
> My situation is this: on my '53 Chevy panel (3105), some PO hit
> something with the back right step hanger, crumpling it and pushing
> the running board back into the right rear fender. The right center
> and right front step hangers were both bent back about two inches in
> the process.
> Now I suppose that the center and front step hangers could be bent
> back some how (big ass hammer?) but the rear one is mangled, and I
> need another one to replace it.
>
> Any suggestions where to look for one?
>
> All three of them look pretty much the same to my untrained eye, but
> the assembly manual has different numbers for the rear (3684103)
> center (3683634) and both front right (3683574) and left (3683573)
> step hangers for the 3100's. If I ended up with the wrong one, I
> imagine I could make it work one way or another.
> Any help on this would be appreciated, it doesn't seem to be a part
> folks want to go to the bother of grinding or chiseling off when
> they're stripping down and old AD for parts.
>
>
> Barrett Revis
> Sparks, NV
>
> '53 3105
> '48 3105
> the fewer the moving parts, the less there is to go wrong...
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|