Bob,
A few months back you were placing rear fenders on a 41-46 and looking for
the bolt placements. Did you ever find the correct location and placement?
Can you share you results with the group.
Thanks,
NHJim
45 Chevy 3104
-----Original Message-----
From: owner-oletrucks@autox.team.net
[mailto:owner-oletrucks@autox.team.net]On Behalf Of Advdesign1@aol.com
Sent: Wednesday, August 29, 2001 7:42 AM
To: oletrucks@autox.team.net
Subject: [oletrucks] Re: AD rear fenders
the repro fenders are no thicker than 19 gauge, and weight 2 pounds less
than
a GM fender. they are well made with corect bends, curves and
reinforcements, but they are just very thin. I was not impressed. I spoke
to Jim carter about this, and he said the chinese frequently use thin metal
to save their dies. I also believe they are thinner than 19ga, as the metal
is most likely metric spec. I wrote down numbers in preparation for an
article about them.
Bob ADler
> I can get Repro steel rear fenders now. They claim that there 18 ga steel
> same as Original but I haven't verified this yet. I called them yesterday
to
> see about fenders with the spare cutout and they acted like I was nuts was
> this a option Bob or ? I have seen a lot of trucks with side mounted
> fenders.
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|