[oletrucks] Hydraulic Lifters

[Pat Bibbs <PatB@iewc.com>]

I'm a semi-novice on this subject.
I have set lash on standard lifters but I'm not sure about hydraulic one.

A new rebuild, new Comp-Cam roller lifters and Crane roller rockers.

Engine has not been started yet.
I understand that it is zero lash, I know how to make sure the valve is
closed.
When I run the nut down on the post, how far should I turn it?
Until it doesn't rattle, then a half turn ? Then set the set screw ?

I just want to make sure I don't go too far.
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959