Bill
If someone put carriage head bolts there they did you a bad deed???? they
should have been Hex, was there allot of rust?? Just cut them off with a
cutting torch but be careful the metal is thin if you like I can send you a
picture of what it supposed to look like, I had a problem with my bottom
inside
Good Luck
HooT58
----- Original Message -----
From: "Bill Broadway" <bcubed@vanhalen-irc.com>
To: <oletrucks@autox.team.net>
Sent: Saturday, May 12, 2001 4:39 PM
Subject: [oletrucks] Bolt question
> I asked a few days ago, but didn't see any replies.
>
> On the door hinges (55 2nd series) the bolts were the hinge goes onto the
> cab, the heads are carriage style (rounded head) .. how in the world do
you
> get them off? There's no head to get a wrnech on and no slot for a screw
> driver .... cutting torch? That's what we're figuring.
>
> Bill
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|